Introducing Potter's IntelliGen™ Nitrogen Generators
Potter’s IntelliGen™ Nitrogen Generator Systems provide a low cost, reliable, and efficient method of producing up to 99% pure nitrogen on-site at the point of usage.
The Model PCMS-RM, is a Corrosion Monitoring Station-Riser Mount consisting of a coupon rack that is installed on fire sprinkler riser to monitor corrosion in a fire sprinkler system. The PCMS-RM is designed to simulate conditions within the fire sprinkler system. The coupon rack can be isolated from the fire sprinkler riser and easily accessed for servicing and monitoring of test specimens(corrosion coupons) without interruption to fire protection. Test material strip specimens (corrosion…Continue Reading
The models PBA-AC and MBA-DC vibrating type bells are designed for use as fire, burglar or general signaling devices. They have low power consumption and high decibel ratings. The unit mounts on a standard 4" (101mm) square electrical box for indoor use or on a model BBK-1 weatherproof backbox or BBX-1 deep weatherproof backbox for outdoor applications. Weatherproof backbox model BBK-1, Stock No. 1500001. Unique Features Available in 6", 8" or 10" Available in…Continue Reading
The Model ADPS is an Adjustable Deadband Pressure Switch with independent set and reset points that are adjustable throughout the entire operating range of the switch. The minimum deadband (minimum span between set and reset points) may be obtained at any point in the operating range of the switch. A change in pressure greater than the high setting will reposition the switch mechanism to open or close a single snap-action electrical switch. The model PCS is a Pump Control Switch with…Continue Reading
Finally, a fire alarm panel designed specifically for sprinkler monitoring! Panels designed for sprinkler monitoring applications are virtually nonexistent. DACT only dialers are severely limited and a traditional fire alarm panel with a DACT is overkill and costly. Potter's new Sprinkler Monitoring Panel is ideally suited to monitor a fire sprinkler system. The first zone of the PFC-6006 is selectable as a Class A or Class B water flow input and the other five zones are selectable…Continue Reading
The Model VSR-SG is a vane type waterflow switch for use on wet sprinkler systems using CPVC plastic fittings. It is equipped with a union to accommodate installation in confined spaces. The Model VSR-ST is a vane type waterflow switch for use on wet sprinkler systems. It is equipped with a union to accommodate installation in confined spaces. Unique Features VSR-SG, The only flowswitch for CPVC pipe Union coupling allows for installation in areas where there isn't room to…Continue Reading